Bauma Light MS1160

REPLACEABLE BOLT-IN LINER

Save time by easily replacing the AR400 steel wear plates on the MS1160 without needing to remove the rotor.

Integrated brush bar

When push comes to shove, the integrated push bar helps control

ROLL BACK TO FELL STANDING TREES

The MS1160’s frame is angled so that you can roll back the Brushy Mulcher, pulling back the pusher bar so that you can fully engage the mulching head. This allows the operator to use the mulching head to fell standing trees.

SPRING LOADED HOSE SUPPORT

Take full advantage of the forward curl and roll back of the MS1160 without risking expensive damage to the hoses. Unique to the Baumalight Brush Mulcher, the spring loaded hose support prevents the hoses from falling into harm’s way during forward curl.

ADJUSTABLE BELT TENSIONER

The adjustable belt tensioner ensures the proper tension of your belts, with no extra idler wheel that could wear out. Simply loosen the bolts and raise the motor mount to tighten the belt.

OPTIONAL TWO-SPEED MOTOR

To maximize the rotor speed and torque to account for changing mulching material, the MS1160 is available with a variable two-speed motor option.

BENT AXIS PISTON MOTORS ARE A STANDARD OPTION

Our industry leading bent axis piston motors make the most use of your hydraulic flow and pressure for your brush clearing needs.

CASE DRAIN – VENT TO ATMOSPHERE

To prevent pressure relief activation on the motor seal, the MS1160 comes with a case drain line and a vent to atmosphere relief valve. In the event there is a spike in pressure in your hydraulic lines, the case drain will relieve the pressure and drain it back into the return line and back to the tank. If the connection of the case drain (third line) is missed or if the line is blocked, then the case drain will vent to notify you. A properly installed case drain protected by a vent to atmosphere relief valve will save the work of replacing your shaft seal and save you from down time of unexpected maintenance.

Wire Protection Kit

If you are mulching and you catch some old fence wire, it can really cause damage to the unit if the wire slips over the edge of the rotor and gets wrapped around the shaft. The wire can get bunched against the bearings, causing major damage. Our wire protection kit contains a welded raised area on the end of the rotor that protects the shaft and prevents wire from getting in.

HEAVY DUTY SKIDSTEER PLATE

Also redesigned for the 1100 Series Brush Mulcher, the skidsteer plate is constructed with heavy duty steel with lots of gusseting and reinforcements.

ENHANCED operator VISIBILITY

The improved design of the MS1160 mulcher head now allows the operator better visibility to the area you are mulching.

Powdered Coated

Our powder coat finish is much tougher than conventional paint to stand up to the rigors of mulching and helps prevent rusting.